【法规名称】
【法规编号】 68863 什么是编号？
【正 文】
第11页 CAP 374A ROAD TRAFFIC (CONSTRUCTION AND MAINTENANCE OF VEHICLES) REGULATIONS
|
[接上页] A tyre shall not be deemed to be of soft or elastic material unless the said material is either- (a) continuous round the circumference of the wheel; or (b) fitted in sections so that so far as reasonably practicable no space is left between the ends thereof,and is of such thickness and design as to minimize, so far as reasonably possible, vibration when the vehicle is in motion, and so constructed as to be free from any defect which might in any way cause damage to the surface of a road. Cap 374A reg 22 Tyres (1) Subject to paragraphs (2) and (7), no wheel of a motor vehicle or trailer shall be fitted with a pneumatic tyre that- (a) is unsuitable having regard to the use to which the motor vehicle or trailer is being put or to the types of tyres fitted to its other wheels; (b) is not so inflated as to make it fit for the use to which the motor vehicle or trailer is being put; (c) has a break in its fabric, or has a cut in excess of 25 millimetres in length or 10 per cent of the section width of the tyre, whichever is the greater, measured in any direction on the outside of the tyre and deep enough to reach the body cords; (d) has any lump or bulge caused by separation or partial failure of its structure; (e) has any portion of the ply or cord structure exposed; or (f) does not- (i) in the case of a motor cycle the cylinder capacity of the engine of which does not exceed 50 cubic centimetres, show throughout at least 3/4 of the breadth of the tread and round the entire outer circumference of the tyre a pattern the relief of which is clearly visible; and (ii) in the case of any other motor vehicle or any trailer, have a tread pattern (excluding any tie-bar) with a depth of at least 1 millimetre throughout at least 3/4 of the breadth of the tread and round the entire outer circumference of the tyre: Provided that this sub-paragraph shall not apply in the case of a motor cycle with sidecar attached having 3 wheels in all, the weight of which does not exceed 100 kilograms and which is incapable of exceeding a speed of 20 kilometres per hour on the level under its own power.(2) Paragraph (1) shall not prohibit the use on a road of a motor vehicle of trailer by reason only of the fact that a wheel of the vehicle or trailer is fitted with a tyre which is not fully inflated if the tyre and the wheel to which it is fitted are so constructed as to make the tyre in that condition fit for the use to which the motor vehicle or trailer is being put and the outer sides of the wall of the tyre are so marked as to enable the tyre to be identified as having been so constructed. (3) No motor vehicle or trailer shall be fitted with a recut pneumatic tyre the fabric of which has been cut or exposed by the recutting process. (4) Without prejudice to paragraphs (1) and (3), all the tyres of a motor vehicle or trailer shall at all times while the vehicle or trailer is used on a road be maintained in such condition as to be fit for the use to which the vehicle or trailer is being put and as to be free from any defect which might in any way cause damage to the surface of the road or danger to persons on or in the vehicle or to other persons using the road. (5) Pneumatic tyres of different types of structure shall not be fitted to the same axle of a vehicle. (6) A motor vehicle or trailer shall not be fitted with- (a) a diagonal-ply tyre or a bias-belted tyre on the rear axle and a radial-ply tyre on the front axle; or (b) a diagonal-ply tyre on the rear axle and a bias-belted tyre on the front axle.(7) Paragraph (1) shall not apply to a land tractor, or land implement, or to an agricultural trailer when the trailer is being towed by a land tractor and nothing in paragraph (1) or (3) shall apply to a broken down vehicle or to a vehicle proceeding to a place where it is to be broken up, in either case being towed by a motor vehicle at a speed not exceeding 20 kilometres per hour. (8) For the purposes of this regulation- "bias-belted tyre" (交叉帘布缓冲层轮胎) means a pneumatic tyre, the structure of which is such that the ply cords extend to the bead so as to be laid at alternate angles of substantially less than 90 degrees to the peripheral line of the tread, and are constrained by a circumferential belt comprising two or more layers of substantially inextensible cord material laid at alternate angles smaller than those of the ply cord structure; "diagonal-ply tyre" (斜纹帘布层轮胎) means a pneumatic tyre, other than a bias-belted tyre, the structure of which is such that the ply cords extend to the bead so as to be laid at alternate angles of substantially less than 90 degrees to the peripheral line of the tread; "radial-ply tyre" (径向帘布层轮胎) means a pneumatic tyre, the structure of which is such that the ply cords extend to the bead so as to be laid at an angle of substantially 90 degrees to the peripheral line of the tread, the ply cord structure being stabilized by a substantially inextensible circumferential belt; |
- 此法规有错误，我来纠正。请点击在此 提交错误内容或者您纠正的内容！